Decorative Wall Siding Panels

The chemical and physical structure of the decorative wall siding panels is stable, it will not decompose, mildew, no radiation, no pollution, and it is green and environmentally friendly.

Send Inquiry

Description

Decorative wall siding panels

wall siding

The middle of decorative wall siding panels is rigid polyuret, which can form a heat insulation and sound insulation layer, and the interior is an independent closed air bubble structure, which has a good sound insulation effect. Moreover, polyurethane is an environmentally friendly raw material, non-toxic, non-polluting, and odorless, which can give buildings green protection and decoration.

exterior wall panel

Advantages

The back of the metal carved board is aluminum foil cloth, which has the functions of heat insulation, heat preservation and moisture resistance.

The use of metal carved panels can greatly reduce heating and cooling energy consumption, thereby saving energy expenditures, high cost performance, and the installation method is simple and fast, and is not limited by seasonal climate and geographical environment, shortening the construction period and speeding up the project. progress and cost savings.

Installation method

Preparation stage: Tools: expansion screw (for concrete and cement brick wall), dovetail nail (for steel structure construction), pistol drill, air nail gun (not necessary), marking pen, tape measure, rubber hammer, cutting machine, etc.

Installation of fitting base: before installing the plate, install the plate fitting base, mainly including the starting part, closing part, edge wrapping, middle seam, internal and external corners, etc.

Installation of plates: after the fitting base is installed, install the first plate horizontally from top to bottom and fix it on the wall with expansion screws or dovetail nails (it is recommended to fix a nail every 60 cm), then insert the female mouth of the second plate downward with the male mouth of the first plate, while tapping the interface of the two plates with a rubber hammer to ensure that the joint of the two plates is tight enough, and then fix the second plate on the wall with expansion screws or dovetail nails, The other plates are then installed in the same way. It should be noted that when the wall size is not consistent with the plate size, the installation should be continued after measuring and cutting.

Install fitting cover plate: after all plates are installed, press the fitting cover plate on the base with force. If it is a fitting of the same material, it shall be fixed on the wall with screws, and then sealed with waterproof glass adhesive.

Remove the protective film: remove the protective film after the plate is installed.

metal sandwich panels